51 43 070 Removing And Installing/Replacing Side Trim Panel, Footwell, On A-Pillar, Left

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front entrance cover strip (inside)
Remove trim panel for pedal assembly .

Detach mucket (1) in area of side trim panel (2).

Release screw (3).

Remove hood/bonnet release lever (4) from side trim panel (2).

Fig 1: Identifying Side Trim Panel, Mucket & Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip side trim panel (3) in direction of arrow from retaining points (2).

If necessary, disconnect associated plug connection and remove side trim panel (3).

Fig 2: Identifying Trim Panel & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Replacement:

Remove switch for unlocking rear lid .

Fig 3: Identifying Trim Panel, Claws & Screws

Courtesy of BMW OF NORTH AMERICA, INC.