51 12... Replacing Rear Bumper Trim (M Technic Aerodynamic Kit)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
IMPORTANT:
The Instructions
on component cementing with doublesided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
Remove trim:
Carefully detach trim (1) from rear bumper with special tool 00 9 317 and hot air blower.
Installation:
Pull protective film (1) off trim (2).
Fit trim (2) over guides (3) into associated mountings on bumper and stick on.