51 14 010 Removing And Installing/Replacing Rear BMW Badge
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools Required
- 00 9 322
IMPORTANT:
The Instructions on component cementing with doublesided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
Heat BMW badge (1) with hot air blower and lever out with special tool 00 9 322 .
Installation:
Pull liner* off adhesive tape (1).
Position badge over guides (2 and 3) and press down firmly.
*Liner is the protective film on a new badge.