32 34 030 Removing and installing/replacing airbag unit (sport steering wheel)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with safety regulations for handling components with gas generators. See 72 00... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
- Do not exert any force on the airbag unit.
- Use only specified tools for releasing the airbag unit.
NOTE:
Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT:
Steering wheel
must be replaced if airbag unit has been triggered!
Follow procedure after airbag triggering . See 72 12... NOTES ON SCRAPPING VEHICLES WITH GAS GENERATORS (AIRBAG SYSTEM) .
Follow procedure after airbag triggering . See 72 12... NOTES ON SCRAPPING VEHICLES WITH GAS GENERATORS (AIRBAG SYSTEM) .
Necessary preliminary tasks:
- Disconnect battery negative lead . See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD (CONVERTIBLE)61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD (COUPE) .
- Remove shift paddles for automatic transmission
Insert Torx screwdriver (T25) at an angle into concealed opening on reverse side of steering wheel until a spring resistance is felt (approx. 1.5 cm).
Increase pressure on spring leg (concealed) using Torx screwdriver (T25) until airbag unit is unlocked.
Repeat procedure on other side.
Installation:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.
WARNING:
Risk of injury!
Airbag unit may only be set down with the airbag itself facing upwards.
Airbag unit may only be set down with the airbag itself facing upwards.
Tilt airbag unit forwards.
Disconnect plug connections and remove airbag unit.
Installation:
Connect plugs to connections of same color on airbag unit.