16 14 500 Removing and installing or replacing control unit for electric fuel pump

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).

Necessary preliminary tasks:

E81, E82, E87, E91 and E92:
Remove backrest side section for right rear. See SEATS - REPAIR (CONVERTIBLE) or SEATS - REPAIR (COUPE) .

Disconnect plug connection (1).

Release nuts (2) and remove control unit (3).

Installation:

Tightening torque 16 14 2AZ, see 16 14 FUEL PUMP .

Fig 1: Identifying Control Unit, Plug Connection And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Except for M3, carry out programming/coding (M3 is not programming - or coding-relevant)