61 31 008 Removing And Installing/Replacing Steering-Column Switch Cluster
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Move wheels into straight-ahead position and do not alter this position during the repair work. Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Necessary preliminary tasks:
Remove STEERING WHEEL
. Remove LOWER SECTION OF STEERING COLUMN TRIM
. If necessary, remove switch for steering column adjustment.
WARNING:
Do not twist the coil spring cassette (1)!
Courtesy of BMW OF NORTH AMERICA, INC.
Disconnect plug connection (1).
Courtesy of BMW OF NORTH AMERICA, INC.
Release screws (1). Tightening torque 61 31 8AZ
. Remove steering-column switch cluster in direction of arrow. Installation note:
The steering column switch cluster is installed in reverse sequence. Carry out steering angle sensor adjustment.
Courtesy of BMW OF NORTH AMERICA, INC.
Replacement:
Remove volute spring cassette. Carry out vehicle programming/encoding.
NOTE:
If replacement of the steering column switch cluster is initiated via Progman, the steering column switch cluster is coded indirectly via the DSC control unit. If coding is cancelled, first adjust the steering angle sensor; this makes a brand-new steering-column switch cluster coding-compatible again if necessary, then code the DSC control unit again.
Carry out steering angle sensor adjustment. Note:
If steering angle sensor adjustment is cancelled, first code the DSC control unit, then adjust the steering angle sensor again.
Vehicles with active steering:
Steering angle sensor is adjusted by means of initial operation / ADJUSTMENT
of active front steering.