11 13 Oil Pan
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
OIL PAN - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Oil drain plug | M12 x 1.5 | 25 Nm | ||
| M18 x 1.5 | 35 Nm | |||
| M22 x 1.5 | 60 Nm | |||
| 2AZ Oil pan on engine block | M6 8.8 | 10 Nm | ||
| M6 10.9 | 12 Nm | |||
| N40 / N42 / N45 / N46 | M8 8.8 | Replace screws | 30 Nm | |
| M8 8.8 | 22 Nm | |||
| Oil sump, lower section to upper section | M6 8.8 | 10 Nm | ||
| N62TU | M8 | 24 Nm | ||
| M8 8.8 | 22 Nm | |||
| Oil sump bottom section to top section with microencapsulated screws | M6 10.9 | Replace screws | 12 Nm | |
| Oil sump upper section to crankcase | N62TU | M6 | 10 Nm | |
| N62TU | M8 | 20 Nm |