34 11 Front Brake E60
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
FRONT BRAKE E60 - TECHNICAL DATA SPECIFICATION
| Attention! New brake pads may only be installed if the brake disc thickness is greater than or equal to the minimum brake disc thickness (MIN TH) (not including M vehicles). In case of M vehicle and perforated brake discs new brake pads may only be installed if the brake disc thickness is greater than the minimum brake disc thickness (MIN TH). Minimum brake disc thickness during general inspection: Nominal size thickness minus 2.4 mm (Not applicable to perforated brake discs and M vehicles) M vehicles and perforated brake discs: Nominal size thickness minus 1.6 mm Depending on:
The brake discs must always be assigned by way of the relevant vehicle identification number and the Electronic Parts Catalogue (ETK)! |
||
| Different thicknesses on brake linings | Max. mm | 0.01 |
| Max. machining limit per friction ring side (M vehicles and perforated brake discs must not be machined). | mm | 0.8 |
| Nominal size (diameter x thickness) | mm | 348x36 |
| Brake disc minimum thickness (MIN TH) stamped on brake disc body | mm | 34.4 |
| Nominal size (diameter x thickness) | mm | 348x30 |
| Nominal size (diameter x thickness) | mm | 324x30 |
| Brake disc minimum thickness (MIN TH) stamped on brake disc body | mm | 28.4 |
| Nominal size (diameter x thickness) | mm | 310x24 |
| Brake disc minimum thickness (MIN TH) stamped on brake disc body | mm | 22.4 |
| Wear warning from residual lining thickness | mm | 3.0 |