84 50 060 Removing and installing/replacing Bluetooth antenna
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2009 BMW 550i, 2008 BMW M5, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove CENTER CONSOLE .
Unfasten plug connection (1) and disconnect.
Detach Bluetooth antenna (2) in direction of arrow from rear-compartment ventilation duct (3).
When replacing dual-lock tape:
- Clean bonding surfaces.
- Stick on dual-lock tape and press down firmly with fingers for at least 2 secs. (ambient temperature at least 18°C).
- Fit Bluetooth antenna on rear-compartment ventilation duct only after a minimum period 30 minutes (strain-free dwell time).
- Subjecting the bond to premature load will result in a loss of adhesion and thus a defective bond => use new dual-lock tape.
Installation:
Fit Bluetooth antenna (1) during installation so that dual-lock tapes (2) and (3) coincide exactly.