72 12 010 Removing and installing/replacing airbag module on left or right front door

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2009 BMW 550i, 2008 BMW M5, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Front and rear airbag modules must not be mixed up.

Necessary preliminary tasks:

Disconnect BATTERY CABLE
Follow INSTRUCTIONS for disconnecting and connecting battery.
Remove FRONT DOOR TRIM .

Unfasten screws.

Carefully remove airbag module.

Installation:

Before installing airbag module, remove all foreign bodies (screws, etc.) from installation recess.

Replace screws.

Tightening torque: see 1AZ in 72 12 AIRBAG MODULES .

Fig 1: Locating Airbag Module Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Danger of mix-up with airbag module of rear door.
Difference:

Coded plug
If the plug does not fit on the module, check whether a module was installed for the rear door.
"VORN / FRONT" and "HINTEN / REAR" printed on