65 82 050 Removing and installing (replacing) onboard monitor

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Proceed with care so as to avoid damaging the on-board monitor and adjoining trims.

Release screws (1).

Fold out on-board monitor (2) in direction of arrow.

Fig 1: Identifying On-Board Monitor

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Installation:

Ensure correct cable routing.

Remove on-board monitor (2).

Fig 2: Identifying On-Board Monitor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .