65 77 730 Removing and installing (replacing) vehicle center sensor

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

WARNING: Note AIRBAG SAFETY INSTRUCTIONS !
Incorrect handling can activate airbag and cause injury.

NOTE: Follow instructions for HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD and cover.
Remove CENTER CONSOLE .

NOTE: Middle rear compartment ventilation duct shown removed for purposes of clarity.

Unfasten plug connection (1) and disconnect.

Release screws (2).

Tightening torque: 8 Nm

Remove vehicle center sensor (3).

Fig 1: Identifying Vehicle Center Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .