65 77 016 Removing and installing/replacing airbag control unit
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Note AIRBAG SAFETY INSTRUCTIONS
!
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE LEAD .
- Remove CENTER CONSOLE .
If necessary, remove rear compartment air duct and disconnect associated plug connections.
Disconnect plug connection (1).
Release screws (2) and remove airbag control unit (3).
Tightening torque: 8 Nm