64 11 875 Removing and installing/replacing servodrive for defrosting flap
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove trim panel for pedal assembly. See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
- Remove air distributor in footwell and side heating duct in rear compartment on left.
Press lock (1) and pull out servodrive for defrosting flap (2) in direction of arrow.
Unfasten plug connection (3) and disconnect.
Installation:
Follow repair instruction " Installing servodrive. "
Servodrive for defrosting flap (2) must snap audibly into place.