64 11 213 Removing and installing/replacing heater - A/C unit fan

Necessary preliminary tasks: 

• Remove storage compartment. See 51 16 200 REMOVING AND INSTALLING STORAGE COMPARTMENT .
• Remove audio system controller / Car Communication Computer. See 65 12 200 REMOVING AND INSTALLING (REPLACING) AUDIO SYSTEM CONTROLLER .
• Remove trim panel for pedal assembly. See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
• Remove right glovebox with housing. See 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING .

Disconnect rear compartment air duct (1) in direction of arrow.

Installation: 

Make sure rear compartment air duct (1) is correctly seated.

Fig 1: Identifying Rear Compartment Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove middle function carrier (2) in direction of arrow.

Installation: 

Make sure middle function carrier (2) is correctly seated.

Ensure correct cable routing.

Fig 2: Identifying Middle Function Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks: 

• If necessary, Remove temperature sensor for cold-air distributor. 

Unfasten plug connection (1) and disconnect.

Release clips (2).

Unfasten plug connection (3) and disconnect.

Remove rear compartment air duct (4) in direction of arrow.

Fig 3: Identifying Rear Compartment Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Make sure rear compartment air duct (4) is correctly seated.

Disconnect left air duct (1) in direction of arrow (2) and (3).

Installation: 

Make sure right air duct (1) is correctly seated.

Fig 4: Identifying Left Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect right air duct (1) in direction of arrow (2) and (3).

Installation: 

Make sure right air duct (1) is correctly seated.

Fig 5: Identifying Right Air Duct

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release screws (2).

Remove cover (3) in direction of arrow.

Installation: 

Ensure correct cable routing.

Make sure seal is correctly seated in cover (3).

Fig 6: Identifying Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove fan for heater - A/C unit (2) in direction of arrow.

Installation: 

Make sure fan for heater - A/C unit (2) is correctly seated.

Fig 7: Identifying Fan For Heater - A/C Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Unlock controller for heater - A/C unit fan (1) with a suitable screwdriver (2) and remove.

Unlock plug connections (3) and disconnect.

Installation: 

Make sure controller for heater - A/C unit fan (1) is correctly seated.

Fig 8: Identifying Controller For Heater - A/C Unit Fan

Courtesy of BMW OF NORTH AMERICA, INC.