63 12 010 Removing and installing/replacing left headlight (xenon headlight)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

Unclip strip (1) in direction of arrow.

Release screws (2) underneath.

Fig 1: Unclipping Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Turn cap (1) approx. 30° counterclockwise and remove from headlight (2).

Fig 2: Turning Headlight Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1)

Unfasten screws (2).

Installation:

Observe BODY GAP DIMENSIONS .
Adjust HEADLIGHTS

Fig 3: Identifying Screws (1)
Courtesy of BMW OF NORTH AMERICA, INC.

Pull bumper panel (1) forwards slightly and feed out headlight (2) in direction of arrow.

Installation:

Make sure headlight (2) is correctly seated in lower holder.

Unlock and disconnect associated plug connections (3).

Remove headlight (2).

Fig 4: Pulling Bumper Panel Forwards

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unclip headlight holder (1) and remove.
Remove IGNITION UNIT AND BULB FOR XENON HEADLIGHT (2) .
Remove CONTROL UNIT FOR XENON HEADLIGHT (3) .

Fig 5: Identifying Headlight Holder And Control Unit For Xenon Headlight
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs (1) on headlight holder (2) must not be damaged.

Make sure headlight holder (2) is correctly engaged on headlight.

Fig 6: Identifying Retaining Lugs On Headlight Holder

Courtesy of BMW OF NORTH AMERICA, INC.