62 30 010 Removing and installing/replacing head-up display
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW M5, 2009 BMW M5, 2009 BMW 550i, 2008 BMW M5, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
IMPORTANT:
Do not scratch head-up display lens!
Necessary preliminary tasks:
- Remove INSTRUMENT PANEL TRIM .
NOTE:
Comply with notes and instructions on HANDLING OPTICAL FIBERS
.
Release screws (1).
Remove air duct (2) from air distributor (3).
If necessary, remove fitted foam seal (4) from head-up display (5).
If necessary, unclip fitted FLEXIBLE SHAFT (DISPLAY ADJUSTMENT) .
Installation:
- Clean head-up display lens.
- Adjust head-up display (5). See HEIGHT ADJUSTMENT and DISPLAY ADJUSTMENT .
- Make sure eccentric (2) is in correct installation position.
- If fitted, make sure flexible shaft is in correct installation position.
Release lock nut (1) and remove.
Remove eccentric (2) in direction of arrow.
Release screws (3).
Pull head-up display (5) back slightly and fold upwards.
Unlock and disconnect plug connection (4) and remove head-up display (5).
Installation:
Make sure centering caps (1) are correctly seated on lugs (2) of head-up display (3).
Replacement:
Carry out vehicle PROGRAMMING/CODING .