61 31 342 Removing and installing/replacing gear selector switch

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection ).

Necessary preliminary tasks:

Disconnect battery negative lead .
Remove trim for storage compartment . See 51 16 211 REMOVING AND INSTALLING/REPLACING FINISHER FOR STORAGE TRAY .

Disconnect plug connection (1).

Release screws (3) and lay emergence release mechanism to one side. Tightening torque, see 61 31 7AZ in 61 31 SWITCH

Release screws (2). Tightening torque, see 61 31 6AZ in 61 31 SWITCH

Remove gear selector switch (4) from center console (5).

Installation:

Align gear selector switch (4) centrally.

Fig 1: Identifying Gear Selector Switch, Centre Console And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Modify spacer bolt.

Carry out vehicle programming/coding.