61 31 270 Replacing switch for reversing light

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The installation location of the reversing light switch can vary, depending on the transmission model.

Necessary preliminary tasks:

If necessary, remove rear underbody protection . See 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION

Version A:

Disconnect plug connection (1).

Release switch for reversing light (2).

Tightening torque, see 61 31 2AZ in 61 31 SWITCH

Fig 1: Identifying Reversing Light And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Version B:

Disconnect plug connection (1).

Release switch for reversing light (2).

Tightening torque, see 61 31 2AZ in 61 31 SWITCH

Fig 2: Identifying Reversing Light And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.