LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1816 (General Electrical System - Repair) >> Switch >> 61 31 006 Removing and installing/replacing fixture for steering column stalk (from 09/2005)

61 31 006 Removing and installing/replacing fixture for steering column stalk (from 09/2005)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Move wheels into straight-ahead position and do not alter this position during the repair work.
Read and comply with notes on protection against electrostatic damage (ESD protection   ).
Comply with notes and instructions on handling optical waveguides. 

Necessary preliminary tasks: 

Disconnect plug connections from rear on fixture for steering column stalk (2).

Release screws (1).

Remove fixture for steering column switch (2) in direction of arrow.

Installation: 

Carry out steering angle sensor   adjustment. 

On vehicles with active front steering, steering angle sensor adjustment is performed by means of initial operation  / adjustment of active front steering. See 32 10 005 ADJUSTMENT FOR ACTIVE FRONT STEERING .

Fig 1: Identifying Column Stalk And Screws
G05513543Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: