61 67 200 Removing and installing/replacing spray nozzle for night vision camera

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010 . See FUEL SYSTEM - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .

To prevent excess escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010.

Fig 1: Identifying Special Tool 13 3 010

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Night vision camera removed for purposes of clarity.

Press retainer (1) and detach high-pressure line (2) from high-pressure nozzle.

Fig 2: Identifying Retainer And High-Pressure Line

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove high-pressure nozzle (2).

Installation:

New spray nozzles are already preset.

Check function.

Fig 3: Identifying High-Pressure Nozzle And Screws

Courtesy of BMW OF NORTH AMERICA, INC.