61 67 083 Removing and installing/replacing left or right high-pressure nozzle of headlight cleaning system

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010 . See FUEL SYSTEM - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove front bumper trim . See 51 11 156 REMOVING AND INSTALLING FRONT BUMPER TRIM .

To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010.

Fig 1: Identifying Special Tool 13 3 010

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high-pressure line (1) and detach from high-pressure nozzle (2).

Release screws (3).

Remove high-pressure nozzle (2).

Installation:

New spray nozzles are already preset.

Carry out a function test before fitting bumper trim.

Fig 2: Identifying High-Pressure Nozzle, High-Pressure Line And Screws

Courtesy of BMW OF NORTH AMERICA, INC.