54 12 117 Replacing seal for glass slide/tilt sunroof lid
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Follow REPAIR INSTRUCTIONS for bonded seals on slide/tilt sunroof
- Open glass lid completely
Begin removal at contact edge (rear center):
- Peel off rubber seal
- Clean bonded area
Installation:
Also begin at specified point of contact edge for installation:
- Stick on rubber seal in sections
- Establish seal joint
- Press on seal