52 26 008 Removing and installing/replacing left/right sides of backrest on rear seat backrest (through-loading)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Pull seat belt to middle and place behind head restraint.

Pull top backrest side section (1) forwards (unclip) remove towards top (2).

Fig 1: Pulling Top Backrest Side Section

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull clip (1) forwards out of sheet metal.

Fig 2: Pulling Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check clip (1) and mount (2) for damage.

Slide clip (1) into mount (2) of backrest side section.

Fig 3: Sliding Clip Into Mount Of Backrest Side Section

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

First feed guides (1 and 3) on backrest side section into mounts (2 and 4) of body.
Then press backrest side section downwards so that guides are correctly seated in mounts.
To finish, clip in backrest side section at top.

Fig 4: Identifying Feed Guides On Backrest Side Section Into Mounts Of Body
Courtesy of BMW OF NORTH AMERICA, INC.