52 24 030 Removing and installing complete armrest (basic) for rear seat backrest

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Pull up cover (1) between armrest and rear seat back.

Release expansion rivets (2) on trim.

Remove trim (3) towards top, feeding out over armrest buckle latch.

Fig 1: Pulling Up Cover Between Armrest And Rear Seat Back

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque: see 5AZ in 52 24 REAR SEAT (NORMAL), MANUAL

Remove armrest (2) towards front.

Fig 2: Identifying Armrest And Screw

Courtesy of BMW OF NORTH AMERICA, INC.