52 24 005 Removing and installing or replacing rear seat

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Unclip rear seat on left/right towards top.

Lift out seat.

Installation:

Feed belt buckles (1) through designated openings into correct location.

Guide lap belt behind seat edge upwards.

Make sure ISOFIX covers are correctly engaged.

Fig 1: Lifting Out Seat

Courtesy of BMW OF NORTH AMERICA, INC.

For op. ext. seat heating only:

Unfasten plug connection.

Fig 2: Locating Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.