52 13 040 Removing and installing/replacing outer cover on left or right front seat (normal/semi-electric)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Pull lever forward to remove:

If necessary, lever out lower locking point (1) from rear with a screwdriver.

Unscrew bolt (2).

If necessary, move seat fully forwards and upwards.

Fig 1: Identifying Bolt And Lower Locking Point

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim:

Unclip at top edge
Unclip at rear towards top side
Pull on belt opening
Unlock lugs
Carefully remove trim towards front Unfasten plug connection.

Fig 2: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Remove switch. See SEAT ADJUSTMENT SWITCH COMBINATION (SEMI-ELECTRIC FRONT SEAT) or SWITCH FOR FRONT LUMBAR SUPPORT .

Installation:

Retaining clips and tabs must not be damaged.

Fig 3: Identifying Retaining Clips And Tabs

Courtesy of BMW OF NORTH AMERICA, INC.