52 17... Removing and installing/replacing all trims on left or right seat rails

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Trim, top rail, front:

Move seat backwards and upwards
Unclip front trim (1) towards top and detach towards top

Fig 1: Unclipping Front Trim
Courtesy of BMW OF NORTH AMERICA, INC.

Trim, top rail, outer:

Move seat forwards and upwards
Unclip front trim towards top and detach towards rear

Fig 2: Identifying Trim, Top Rail And Outer
Courtesy of BMW OF NORTH AMERICA, INC.

Trim, bottom rail, front, outer:

Move seat backwards
Unclip trim tongue towards top, sliding trim towards front slightly
Pull inner trim section inwards slightly and unclip
Detach trim towards front from bottom rail

Installation:

Place trim on bottom rail and slide towards rear to engage, feeding in below trim, top rail, outer.

Fig 3: Unclipping Tongue

Courtesy of BMW OF NORTH AMERICA, INC.

Trim, bottom rail, front, inner:

Move seat backwards
Unclip tongue (1) towards top and detach trim towards front

Fig 4: Raising Bridge On Front Right Seat Rail Cover
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure hook (1) engages in slot (2).

Fig 5: Hook (1) Engages In Slot (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Trim, bottom rail, rear:

Move seat forwards
Unclip trim tongue towards top
Briefly pull inner trim section inwards
Detach trim towards rear from bottom rail

Fig 6: Detaching Trim Towards Rear From Bottom Rail
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips and hooks must not be damaged.

Make sure trims are exactly seated.

After completing tasks, move seat and make sure that trim does not move.