51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow SAFETY INSTRUCTIONS for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Detach mucket (1) in area of panel (2).

Unclip protective cap (3) and remove.

Fig 1: Removing Mucket And Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: see 2AZ in 51 43 SIDE TRIM PANEL WITH ARMRESTS

Unclip panel (2) at fastening point (3).

Feed out panel (2) from instrument panel (4) and remove.

Fig 2: Removing Panel From Instrument Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clip (1) remaining in bore.

If necessary, replace faulty clip (1).

Make sure guide (3) of panel (2) is correctly seated in associated mounting.

Position panel (2) preinstalled with clip (1) on associated bore and clip into place.

Fig 3: Identifying Guide, Panel And Clip

Courtesy of BMW OF NORTH AMERICA, INC.