51 12 810 Removing and installing / replacing deformation element on bumper carrier on left or right

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove CARRIER FOR REAR BUMPER TRIM

Release screws (1).

Remove locator (2) straight towards rear.

Tightening torque: see 3AZ in 51 12 REAR BUMPER

Fig 1: Identifying Screws And Locator

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Foam seal (1) on locator (2) must not be damaged.

Fig 2: Identifying Foam Seal On Locator

Courtesy of BMW OF NORTH AMERICA, INC.