51 45 181 Removing and installing/replacing bottom right trim for instrument panel

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Move front passenger seat completely towards rear.

Drive bottom trim (1) towards rear with special tool 00 9 317 and remove.

Installation:

Make sure bottom trim (1) is correctly seated at retaining points (2).

Feed bottom trim (1) correctly into bottom right trim for instrument panel (3).

Fig 1: Removing Bottom Right Trim For Instrument Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

IMPORTANT: Carefully remove bottom right trim for instrument panel.

Move bottom right trim for instrument panel (2) slightly forwards and feed out towards rear.

Disconnect plug connection of footwell light (3).

Remove bottom right trim for instrument panel (2).

Fig 2: Removing Bottom Right Trim For Instrument Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Mounts (1) and guides (2) of bottom right trim for instrument panel (3) must not be damaged.

Make sure mounts (1) are correctly seated.

Replacement:

Remove FOOTWELL LIGHT (4) .

Fig 3: Identifying Mounts And Guides Of Bottom Right Trim For Instrument Panel
Courtesy of BMW OF NORTH AMERICA, INC.