51 32 170 Removing and installing/replacing front left or right door window glass (Security)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

IMPORTANT: The insides of the windows have a polycarbonate coating which must not be damaged or scratched.
Clean with antistatic plastic cleaner only.

Connect special tool 61 3 060 to plug connection (1) and special tool 61 2 071 .

IMPORTANT: Energize power window unit for max. 0.5 seconds in end position (risk of damage).
Energize special tool 61 2 071 with 12V, the door window opens or closes through polarity reversal.

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Open door window glass to gain access to screws (1).

Slacken bolts (1)

Tightening torque: see 2AZ in 51 32 FRONT DOOR WINDOWS

Version with window heating:

Disconnect plug connection for window heating lead (braided sleeve) on door side. Pay attention to routing for subsequent installation.

Installation:

If necessary, check ease of movement of window heating lead.

Fig 2: Identifying Door Window Glass Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Turn door window glass and lift out towards rear/top.

Installation:

Adjust door window glass.

Fig 3: Removing Door Window Glass

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

INITIALIZE power windows

Check function.

IMPORTANT: Power windows have no anti-trapping mechanism.
There is no "Close" one-touch function or "Close" comfort function in the Security version.