51 48 001 Removing and installing/replacing insulation lining on hood/bonnet

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Illustration created using the E87 as an example. There may be differences in detail in the case of other vehicle models.

Release threaded rivets (1) on insulation lining (2).

Remove insulation lining (2).

Installation:

If necessary, replace defective threaded blind rivets (1).

Fig 1: Identifying Threaded Rivets On Insulation Lining

Courtesy of BMW OF NORTH AMERICA, INC.