51 11... Installing/replacing license plate (without base)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque: see 7AZ in 51 11 FRONT BUMPER

Fit protective caps.

Fig 1: Drilling Hole Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1)*.

Secure license plate (3) with license plate screw (4)*.

Tightening torque: see 8AZ in 51 11 FRONT BUMPER

Fig 2: Identifying License Plate And License Plate Screw

Courtesy of BMW OF NORTH AMERICA, INC.