51 14 110 Removing and installing/replacing rear model designation (Brilliance)
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING serve as the basis for these repair instructions and must be followed without fail.
Attach adhesive tape (1) between edge of rear lid (3) and top edge measurement "A".
Mark measurement "B" from outer edge of rear lid on adhesive tape (1) and stick on adhesive tape (2) vertically.
Measurements:
- = 18 mm
- = 38 mm
Pull off liner (protective strip for adhesive surface).
Position characters on adhesive tapes (1 and 2) and stick into place.