34 00 009 Checking brakes on test stand
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Check tires for damage
- Check Tyre treads
- Check Tyre pressure
In the case of vehicles with DSC, the system must be deactivated with the switch. The DSC telltale and warning light must light up in the instrument cluster!
The brakes must be at normal operating temperature. For this purpose, gently warm up the brake disks/drums while dry by braking the vehicle several times.
E65 and E66: Carry out function check on parking brake.
IMPORTANT:
Only brake test stands (dynamic analyzers) with test speeds of 2.5-6 km/h may be used.
You must follow without fail the guidelines contained in the operating instructions of the relevant test stand manufacturer.
Failure to do so may result in damage to the vehicle and the system and also personal injury.
You must follow without fail the guidelines contained in the operating instructions of the relevant test stand manufacturer.
Failure to do so may result in damage to the vehicle and the system and also personal injury.