33 11... Replacing rear cover gasket on rear differential (188K)
WARNING: This page is about a different car, the 2009 BMW 550i and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
To avoid leaks from the rear differential cover, do not use a paper gasket in cars with liquid gaskets!
To prevent the differential oil from foaming over, make sure that no remnants of the liquid gasket are pressed into the rear differential housing.
To prevent the differential oil from foaming over, make sure that no remnants of the liquid gasket are pressed into the rear differential housing.
Release screws (1).
Tightening torque (M10x75) 33 11 1AZ . See 33 11 REAR DIFFERENTIAL CASE WITH COVER .
Unscrew screws (2).
Tightening torque (M10x25) 33 11 1AZ . See 33 11 REAR DIFFERENTIAL CASE WITH COVER .
Remove cover.
If necessary, remove remnants of liquid gasket with scraper.
Clean sealing face on cover and rear differential.
Installation:
If a paper gasket was fitted, a paper or liquid gasket can be used.