33 33 001 Replacing left or right rear axle carrier compression strut
WARNING: This page is about a different car, the 2009 BMW 550i and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions
for raising the vehicle Driving without
tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Necessary preliminary tasks:
- If necessary, remove rear tension strut .
- Remove tank cover
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from tension strut. See 37 13 110 REMOVING AND INSTALLING/REPLACING PRESSURE LINE FOR OSCILLATING MOTOR/REAR AXLE .
Release screws (2).
Tightening torque 33 32 17AZ . See 33 32 CONTROL ARMS AND STRUTS .
Release bolt (1) and remove compression strut.
Secure rear axle carrier by inserting bolt (1).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread inserts .
Tightening torque 33 33 3AZ . See 33 33 REAR AXLE SUSPENSION .