32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out preliminary work in replacing drive belt.
See 11 28 010 REPLACING ALTERNATOR DRIVE BELT (N62/N62TU)
.
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2).
Unscrew bolts (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) must point forwards.
Tightening torque, see 32 41 14AZ in 32 41 PUMP AND OIL SUPPLY