32 41 061 Replacing power steering vane pump
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of poisoning
if oil is ingested/absorbed through the skin!
Risk of injury if oil comes into contact with eyes and skin!
Risk of injury if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
- Remove vane pump
Release screws (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) points forwards.
Tightening torque, see 32 41 14AZ in 32 41 PUMP AND OIL SUPPLY
After installation:
- Fill and bleed hydraulic system. See 32 13 006 Bleeding power steering (version with Dynamic Drive) or 32 13 006 Bleeding power steering unit
- Check pipe connections for leaks
- Version with Dynamic Drive: If necessary, carry out initial Dynamic Drive operation . See 37 10 001 INITIAL OPERATION WITH TEST RUN OF DYNAMIC DRIVE .