22 11 100 Replacing right engine support arm (N62)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure engine in installation position.
Remove both front wheels .
Remove underbody protection.
Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
Lower front axle support . See FRONT SUB-FRAME

Observe safety instructions on raising the vehicle . See 00 MAINTENANCE AND GENERAL INFORMATION .

Release grounding strap (1) from engine support arm.

NOTE: Clean contact surfaces to ensure a safe ground connection.
Release screws (2) and nut (3) and remove engine support arm.

Tightening torque 22 11 2AZ/3AZ . See ENGINE AND GEARBOX SUSPENSION (MOUNTS) - TIGHTENING TORQUES .

Fig 1: Identifying Grounding Strap, Screws And Nut

Courtesy of BMW OF NORTH AMERICA, INC.