22 11 001 Replacing right engine mount (N62)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure Engine In Installation Position see 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N62, N62TU) .
Remove underbody protection.
Remove both front wheels .
Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
Lower front axle support . See FRONT SUB-FRAME .

Observe safety instructions on raising the vehicle . See 00 MAINTENANCE AND GENERAL INFORMATION .

Release nut (1) and screws (2).

Tightening torque 22 11 1AZ/2AZ . See ENGINE AND GEARBOX SUSPENSION (MOUNTS) - TIGHTENING TORQUES .

Remove engine mount.

NOTE: Illustrations show M57.

Fig 1: Identifying Engine Mount Nut And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lug (1) of engine mount must point to middle of vehicle.

Engine mount designations:

ENGINE MOUNT DESIGNATIONS

Right engine mount:	Even component number
Left engine mount:	Odd component number

Fig 2: Identifying Lug

Courtesy of BMW OF NORTH AMERICA, INC.