12 14 526 Replacing pulse generator on right inlet camshaft (N62, N62TU)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

Read out fault memory of DME control unit; if necessary, work through test schedules
Switch off ignition
Remove acoustic cover by removing 4 screws. Raise cover and remove toward front.

Fig 1: Identifying Acoustic Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove right ignition coil cover

Release plug connector (1) and pull off.

Fig 2: Identifying Plug Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Remove pulse generator (2).

Installation:

Replace sealing ring and coat with antiseize agent.

Fig 3: Identifying Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.