12 14 521 Replacing crankshaft pulse generator (N62, N62TU)
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Read out fault memory of DME control unit; if necessary, work through test schedules
- Switch off ignition
- If necessary, remove underbody protection.
Installation location:
On transmission housing at bottom right.
Unlock plug (1) and remove.
Release screw.
Withdraw pulse generator (2) from transmission housing.
Installation:
Replace sealing ring.
Replace screw.
Installation:
Now clear the fault memory.