00 00 555 Interrogating fault memories in diagnosis system
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Connect diagnostic system to OBD socket.
Switch on ignition.
Carry out vehicle identification.
Click on Brief test.
The brief test is carried out.
NOTE:
For motor vehicle diagnostics, the brief test is essential for evaluating possible stored diagnostic trouble codes. In the brief test, the control units are physically identified in succession and their fault memories read out.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.