64 53... Replacing valve insert for refrigerant line
WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury!
Refrigerant circuit is under high pressure!
Follow safety instructions for HANDLING R 134A REFRIGERANT .
Follow safety instructions for HANDLING REFRIGERANT OIL .
Avoid contact with refrigerant and refrigerant oil.
IMPORTANT:
Risk of damage!
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit!
If A/C system is opened for more than 24 hours: REPLACE DESICCANT INSERT FOR A/C SYSTEM
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit!
If A/C system is opened for more than 24 hours: REPLACE DESICCANT INSERT FOR A/C SYSTEM
Necessary preliminary tasks:
- DRAWING OFF, EVACUATING AND FILLING THE A/C SYSTEM are not included in the time value given for this work operation
Twist valve insert out of filler neck (2) with remover (1).
Installation note:
Screw in valve insert hand-tight only.
After installation:
- EVACUATE AND FILL A/C SYSTEM
- Check leak-tightness of valve insert with soapy solution
In event of leakage:
- EVACUATE A/C system
- Check sealing faces on line and valve insert for damage, replace line or valve insert if necessary
- If necessary, carry out LEAK DETECTION