64 53 551 Removing and installing or replacing condenser for A/C system

WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Risk of injury!

Refrigerant circuit is under high pressure!

Follow safety instructions for HANDLING R 134A REFRIGERANT .

Avoid contact with refrigerant and refrigerant oil.

Follow safety instructions for HANDLING REFRIGERANT OIL .

IMPORTANT:

Risk of damage!

Restart engine only when A/C system has been correctly filled.

Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit!

If A/C system is opened for more than 24 hours: REPLACE DESICCANT INSERT FOR A/C SYSTEM

Necessary preliminary tasks:

DRAWING OFF, EVACUATING AND FILLING THE A/C SYSTEM are not included in the time value given for this work operation

IMPORTANT: Do not place front panel center section (2) on jump start terminals.
Do not kink Bowden cables for engine hood locking.

Release screws (1).

Remove front panel center section (2) in direction of arrow and place to one side.

Fig 1: Releasing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove radiator cover (2) in direction of arrow.

Fig 2: Removing Radiator Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation note:

Tightening torque 64 53 6AZ .

Remove refrigerant lines (2) in direction of arrow and place to one side.

Installation note:

Replace all sealing rings and moisten with refrigerant oil .

Pull out condenser for A/C system (3) in direction of arrow.

After installation:

EVACUATE AND FILL A/C SYSTEM

Fig 3: Removing Refrigerant Lines

Courtesy of BMW OF NORTH AMERICA, INC.