32 41 250 Removing and installing/replacing fluid reservoir for power steering

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 1 260

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.

Necessary preliminary tasks:

Draw off and dispose of hydraulic fluid from fluid reservoir
M54, N52, N53, N54: Remove intake filter housing

Release screw (1).

Tightening torque 32 41 9AZ .

NOTE: If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.

Remove hose clamps if necessary with special tool 32 1 260 .

Disconnect suction and cooler return lines from fluid reservoir, check and if necessary replace.

Lift out fluid reservoir.

Fig 1: Lifting Out Fluid Reservoir

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Fill and bleed HYDRAULIC SYSTEM
Check pipe connections for leaks