32 33 001 Removing and installing (replacing) steering wheel (up to 03/2007)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Wheel/chassis alignment is not necessary after the steering wheel has been removed and installed or replaced.

Necessary preliminary tasks:

Remove AIRBAG UNIT
Replacement only: Remove RETAINING PLATE FOR MULTIFUNCTION STEERING WHEEL SWITCH

Move wheels/steering wheel into straight-ahead position.

Disconnect plug connection(s) and remove connecting lead(s) from steering wheel.

Release screw (1) and remove steering wheel.

Secure volute spring cassette with adhesive tape against twisting.

Installation:

Make sure connecting lead(s) is/are correctly laid.

Tightening torque 32 33 1AZ .

Fig 1: Removing Steering Wheel

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Locking pin (1) must engage in recess of driver (2).

Installation:

Align steering wheel using grooved toothing to steering column and attach.

Fig 2: Identifying Locking Pin And Driver

Courtesy of BMW OF NORTH AMERICA, INC.