32 31 102 Replacing sleeve for steering spindle (4WD)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not kink floor panelling under any circumstances!
After installation:
- Carry out STEERING ANGLE SENSOR ADJUSTMENT
Necessary preliminary tasks:
- Remove LOWER SECTION OF STEERING SPINDLE
- Remove ACCELERATOR PEDAL MODULE
- Take floor panelling out of bulkhead and secure
Release nut (1) and press cable duct a little to one side.
Remove sleeve (2) from bulkhead.
Installation:
Grease/spray sleeve (2) from outside with silicone grease.
Align sleeve (2) by way of arrow to bulkhead and insert.
Check seating of sleeve (2), correct if necessary.